Fail Safe System

FAIL-SAFE SYSTEM




Output failure
When the ignition switch is in the ON position, if any of the parts (indicated in the following chart) move more than the specified amount within a period "T2" when no "ON" input is sent from any of the switches (indicated in the following chart), or an output from the automatic drive positioner is not produced, an output failure is sensed. Motor operation will be suspended automatically, and all automatic operations will be ineffective. (In this case, the motor will not operate manually.)

Absolving
- When moving selector lever back to "P" position after having moved it to any position except "P", fail-safe operation will be canceled.
- If self-diagnosis is performed using CONSULT-II, fail-safe operation will be canceled.

INITIALIZATION
After reconnecting battery cable, perform initialization procedure A or B. If initialization has not been performed,
automatic drive positioner will not operate.

PROCEDURE A
1. Insert key in the ignition key cylinder. (Ignition switch is in "OFF" position.)
2. Open -> close -> open driver side door. (Do not perform with the door switch operation.)
3. End

PROCEDURE B
1. Drive the vehicle at more than 30 kph (19 MPH).
2. End