With Manufacturer's Scan Tool (Consult-II)
IVMS COMMUNICATION DIAGNOSIS
1. Touch "IVMS COMM DIAGNOSIS" in "IVMS-COMM CHECK".
2. Touch "START".
3. It no DTC is detected, inspection is end.
If any problem code is displayed, repair/replace the system according to the IVMS communication diagnosis results.
4. Erase the diagnostic results memory.
a. Turn ignition switch "ON".
b. Touch "IVMS".
c. Touch "IVMS COMM DIAGNOSIS" in "IVMS-COMM CHECK".
d. Touch "START" for "IVMS COMM DIAGNOSIS".
e. Touch "ERASE".
WAKE-UP DIAGNOSIS
1. Touch "WAKE-UP DIAGNOSIS" in "IVMS-COMM CHECK".
2. Touch "START' for "WAKE-UP DIAGNOSIS".
3. After touching "START", turn ON switch designated on CONSULT-II display within 15 seconds.
4. If no DTC is detected, touch "NEXT" and perform wake-up diagnosis for next LCU or touch "END". (INSPECTION END)
If any problem is displayed, replace the LCU.
If "SW DATA UNMATCH" is displayed, touch "RETEST" and perform wake-up diagnosis again.
IVMS COMMUNICATION DIAGNOSES RESULTS LIST - 1
NOTE: When CONSULT-II indicates [PAST COMM FAIL] or [PAST NO RESPONSE], erase the memory and perform communication diagnoses again.
To erase the memory, perform the procedure below.
Erase the memory by CONSULT-II or turn the ignition to "OFF" position and remove 7.5 A fuse [No.14, located in the fuse block (J/B)].
IVMS COMMUNICATION DIAGNOSES RESULTS LIST - 2
NOTE: When CONSULT-II indicates [PAST COMM FAIL] or [PAST NO RESPONSE], erase the memory and perform communication diagnoses again.
To erase the memory, perform the procedure below.
Erase the memory by CONSULT-II or turn the ignition to "OFF" position and remove 7.5 A fuse [No. 14,located in the fuse block (J/B)].
IVMS COMMUNICATION DIAGNOSES RESULTS LIST - 3
NOTE: When CONSULT-II indicates [PAST COMM FAIL] or [PAST NO RESPONSE], erase the memory and perform communication diagnoses again.
To erase the memory, perform the procedure below.
Erase the memory by CONSULT-II or turn the ignition to "OFF" position and remove 7.5 A fuse [No. 14,located in the fuse block (J/B)].