Trunk / Liftgate Weatherstrip: Locations

1 - Radiator core support sealing rubber:

2/3 - Cowl top seal and cowl top grille, 4 - Windshield side molding (Mounted with screws):

5 - Windshield upper molding:

6 - Drip weatherstrip:

7 - Body side welt:

8 - Door weatherstrip:

9 - Door sash molding:

10 - Front door parting seal:

11 - Door outside molding:

12 - Sunroof lid weatherstrip:

13 - 14 - Rear window upper molding and side molding:

15 - Rear window lower molding:

17 - Side guard molding:

16 - Trunk lid weatherstrip:

18 - Licence plate finisher, 19 - Rear combination lamp (Rear Combination Lamps Are Installed With Nuts):

20 - Rear air spoiler:

21 - Front hood grille:

22 - Mudguard center:

- When removing, first disconnect high-mounted stop lamp connector located on the back of trunk lid, then remove air spoiler taking care the stop lamp harness does not get caught.
- When installing, make sure that there are not gaps or waves at ends of air spoiler.
- Before installing spoiler, clean and remove oil from surface where spoiler will be mounted.
- With a vehicle coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No.4210 or equivalent, after priming with 3M primer Product No. N-200 or C-100 or equivalent.