Line Pressure Test

LINE PRESSURE TEST





LINE PRESSURE TEST PORTS
- Location of line pressure test ports.
- Always replace line pressure plugs as they are self-sealing bolts.

LINE PRESSURE TEST PROCEDURE
1. Check A/T fluid and engine oil levels. If necessary, add fluid.





2. Drive vehicle for approx. 10 minutes or until engine oil and ATF reach operating temperature.
ATF operating temperature: 50 - 80°C (122 - 176°F)








3. Install pressure gauge to corresponding line pressure port.





4. Set parking brake and block wheels.
- Continue to depress brake pedal fully while line pressure test is being performed at stall speed.





5. Start engine and measure line pressure at idle and stall speed.
- When measuring line pressure at stall speed, follow the stall test procedure.
Line pressure: Refer to; Specifications; Mechanical Specifications




JUDGEMENT OF LINE PRESSURE TEST