TAC Module

HOW TO ERASE SELF-DIAGNOSTIC RESULTS (Malfunction codes)





- With accelerator pedal fully depressed (full-open throttle), turn neutral position switch "OFF" and place shift lever in any position other than "P" or "N".
- After turning ignition switch "ON" (engine off), turn neutral position switch "ON" and place shift lever in "P" or "N". Release accelerator pedal (full-closed throttle).
- Items indicated in the following table can be erased as per conditions without using erasure procedures outlined above. These items are erased under conditions outlined in the table.
After the erase operation is completed, it is necessary to rerun the self-diagnostic mode to verify that malfunction codes no longer appear. Only the Code No. 5 should be indicated when erase operation is completed and system is functioning normally.