Reading and Clearing Diagnostic Trouble Codes

Consult Inspection Procedure



1. Turn Ignition switch "OFF".
2. Connect "CONSULT" to the data link connector.




3. Turn Ignition switch "ON".
4. Touch "START".




5. Touch "IVMS"




6. Touch "MULTI-REMOTE CONT SYS"




- DATA MONITOR, and ACTIVE TEST are available for the multi-remote control system




Work Flow

NOTE
- When Local Control Unit (LCU) connectors are disconnected for more than 1 minute such as during trouble diagnoses, the "disconnected" data will be memorized by the Body Control Module (BCM). Therefore, after reconnecting the LCU connectors, erase the memory
- To erase the memory, perform the procedure below. Erase the memory with CONSULT or turn the ignition switch to "OFF" position and remove 7.5 A fuse (No. (14), located in the fuse and fusible link box).

Trouble Symptom




- All functions of remote control system do not function.




- Multi-remote controller does not operate a part of the functions.

NOTE:
- The unlock and trunk open operation of multi-remote control system does not activate with the ignition key inserted in the ignition key cylinder
- The lock operation of multi-remote control system does not activate with the key inserted in the ignition key cylinder or if one of the doors is opened.





Diagnostic Procedure 1
NOTE: Remote controller does not function if battery is not set correctly.





Diagnostic Procedure 2








Diagnostic Procedure 3





Diagnostic Procedure 4





Diagnostic Procedure 5





Diagnostic Procedure 6