Diagnosis Using Warning Lamp - Flash Code Charts

Inspecting SRS malfunctioning parts by using "AIR BAG" warning lamp - Diagnosis mode

NOTE: SRS will not enter Diagnosis mode if no malfunction is detected in User mode.







1. Open driver's door.

2. Turn ignition switch from "OFF" to "ON".

3. Press driver's door switch at least 5 times within 7 seconds after turning ignition switch "ON". SRS is now in Diagnosis mode.







4. "AIR BAG" warning lamp operates in Diagnosis mode as shown.

NOTE: If SRS does not enter Diagnosis mode even though malfunction is detected in User mode, refer to Testing and Inspection / Diagnostic Procedures / Procedure 11 SRS Does Not Enter Diagnostic Mode.

5. Malfunctioning part is indicated by the number of flashes (part d or f) Compare the number of flashes to AIR BAG WARNING LAMP FLASH CODE CHART, and locate malfunctioning part.
6. Turn ignition switch "OFF", and disconnect both battery cables.

7. Repair the system as outlined by the "Repair order" in AIR BAG WARNING LAMP FLASH CODE CHART that corresponds to the flash code.
8. After repairing the system, refer to Diagnostic Procedures / Procedure 5 Final Check After Repairing - Using Warning Lamp.













Air Bag Warning Lamp Flash Code Charts (Diagnostic Mode)