Without Scan Tool
SELF-DIAGNOSISFUNCTION
- When a problem occurs in the ABS, the ABS warning lamp on the instrument panel comes on. When a problem occurs in the TCS, the TCS OFF indicator lamp and SLIP indicator lamp on the instrument panel comes on. To actuate the self-diagnostic results mode, ground the self-diagnostic (check) terminal located on "Data ink connector for CONSULT". The location of the malfunction is indicated by the ABS warning lamp or SLIP indicator lamp flashing.
- Without TCS A self-diagnostic result is indicated by means of the ABS warning lamp.
- With TCS A self-diagnostic result is indicated by means of the SLIP indicator lamp.
Part 1 Of 2:
Part 2 Of 2:
SELF-DIAGNOSIS PROCEDURE
NOTE: The indication terminates after five minutes. However, when the ignition switch is turned from "OFF" to "ON" the SLIP indication starts flashing again. The TCS OFF indicator lamp and ABS warning lamp remain lighted.
HOW TO READ SELF-DIAGNOSTIC RESULTS (Malfunction codes)
- Determine the code number by counting the number of times the ABS warning lamp or SLIP indicator lamp flashes on and off.
- When several malfunctions occur at one time, up to three code numbers can be stored; the latest malfunction will be indicated first.
- The indication begins with the start code 12. After that a maximum of three code numbers appear in the order of the latest one first. The indication then returns to the start code 12 to repeat (the indication will stay on for five minutes at the most).
- The malfunction code chart is given.