Case Components
REMOVAL AND INSTALLATIONInput Shaft Oil Seal
1. Drive out input shaft oil seal.
2. Install input shaft oil seal.
^ Apply multi-purpose grease to seal lip of oil seal before installing.
Input Shaft Rear Bearing
1. Remove Welch plug from transmission case.
2. Remove input shaft rear bearing by tapping it from Welch plug hole.
3. Install Welch plug.
^ Apply recommended sealant to mating surface of transmission case.
4. Install input shaft rear bearing.
Mainshaft Front Bearing and Oil Channel
1. Remove mainshaft front bearing retainer.
2. Remove mainshaft front bearing.
3. Remove oil channel.
4. Install oil channel.
^ Ensure that oil groove in oil channel always faces toward oil pocket when installing it on clutch housing.
5. Install mainshaft front bearing.
6. Install mainshaft front bearing retainer.
^ Apply locking sealant to thread of screw before installation.