Frontal Collision

To repair the SRS for a frontal collision, perform the following steps.

When SRS (except the side air bag) is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules (except the side air bag module) and seat belt pre-tensioner assemblies.
3. Check the SRS components using the table shown below:
-Replace any SRS components showing visible signs of damage (dents, cracks, deformation).

4. Install new air bag modules (except the side air bag module) and seat belt pre-tensioner assemblies.
5. Conduct self-diagnosis using CONSULT, "AIR BAG" and "SEAT BELT" warning lamps. Refer to "Self diagnosis" for details. Ensure entire SRS operates properly.

When SRS is not activated in a collision:
1. Check the SRS components using the table shown below:
Replace any SRS components showing visible signs of damage (dents, cracks, deformation)

2. Conduct self-diagnosis using CONSULT, "AIR BAG" and "SEAT BELT" warning lamps. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly.

Part 1 Of 2:

Part 2 Of 2:

SRS inspection