Diagnostic Procedure 4

Final checking after repairing SRS by using CONSULT - Diagnosis mode






1. After repairing SRS, connect both battery cables.
2. Connect CONSULT to Data link connector.
3. Turn ignition switch from "OFF" to "ON".






4. Touch "START".






5. Touch "AIRBAG".






6. Touch "SELF-DIAG [CURRENT]".






7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed.

When the malfunction was only in seat belt pre-tensioner system, go to step ii. When the malfunction was not only in seat belt pre-tensioner system, touch "ERASE".

If any problem code is displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2, and repair malfunctioning part completely.






8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

It the memory of the malfunction is "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.






9. Touch "BACK" key of CONSULT to select "SELF-DIAG [PAST]" in the "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".






10. Check that no self-diagnostic failure is detected on "SELF-DIAG [PAST]".

NOTE: Past malfunction for seat belt pretensioner system will not be displayed on "SELF-DIAG [PAST]".

11. Touch "BACK" key of CONSULT until SELECT SYSTEM appears in order to return to User mode from Diagnosis mode, turn off CONSULT, then disconnect CONSULT
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1, to check SRS operation by using "AIR BAG" warning lamp with User mode.