With Manufacturer's Scan Tool (CONSULT II)

CONSULT INSPECTION PROCEDURE
1. Turn off ignition switch.




2. Connect "CONSULT" to data link connector for CONSULT (Data link connector for CONSULT is located behind the fuse box cover.)
3. Turn on ignition switch.




4. Touch "START".




5. Touch "ENGINE".







6. Perform each diagnostic test mode according to each service procedure.
For further information, see the CONSULT Operation Manual.
This sample shows the display when using the UEOBD98 program card. Screen differs in accordance with the program card used.




ECCS COMPONENT PARTS/CONTROL SYSTEM APPLICATION

How to Erase DTC (With CONSULT)

NOTE: If the diagnostic trouble code is not for A/T related items, skip steps 2 through 4.




1. If the ignition switch stays "ON" afier repair work, be sure to turn ignition switch "OFF" once. Wait at least 5 seconds and then turn it "ON" (engine stopped) again.
2. Turn CONSULT "ON" and touch "A/T".
3. Touch "SELF-DIAG RESULTS".
4. Touch "ERASE". [The DTC in the TCM (Transmission Control Module) will be erased.] And touch "BACK" twice.
5. Touch "ENGINE".
6. Touch "SELF-DIAG RESULTS".
7. Touch "ERASE". (The DTC in the ECM will be erased.)
- If DTCs are displayed for both ECM and TCM (Transmission Control Module), they need to be erased individually for both ECM and TCM (Transmission Control Module).