Procedure 2 Inspecting Malfunctioning Parts - Using CONSULT Scan Tool

Inspecting SRS malfunctioning parts by using CONSULT - Diagnosis mode







1. Turn ignition switch "OFF".

2. Connect "CONSULT" to Data link connector.






3. Turn ignition switch "ON".

4. Touch "START".






5. Touch "AIRBAG".






6. Touch "SELF-DIAG [CURRENT]".






7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".






If no self-diagnostic failure is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in DIAGNOSTIC PROCEDURE 1, check the battery voltage. If the battery voltage is less than 9V, charge the battery. Then go to DIAGNOSTIC PROCEDURE 4 for final checking. It the battery voltage is OK, go to DIAGNOSTIC PROCEDURE 6, to diagnose the following situations:

- Self-diagnostic failure "SELF-DIAG[PAST]"(previously stored in the memory) might not be erased after repair.

- The SRS system malfunctions intermittently.

8. Touch "PRINT".

9. Compare diagnostic codes to the CONSULT DIAGNOSTIC CODE CHART.

10. Touch "BACK" key of CONSULT until SELECT SYSTEM appears in order to return to User mode from Diagnosis mode, then turn off CONSULT.

11. Turn ignition switch "OFF", then disconnect CONSULT and both battery cables.

12. Repair the system as outlined by the "Repair order" in CONSULT DIAGNOSTIC CODE CHART that corresponds to the problem code. For replacement procedure of component parts.

13. After repairing the system, go to DIAGNOSTIC PROCEDURE 4 for final checking.

Part 1 Of 2:

Part 2 Of 2:

Consult Diagnostic Code Chart ("Self-DIAG [Current]")