With Manual Transaxle

WARNING:
- DO NOT REMOVE ENGINE UNTIL EXHAUST SYSTEM HAS COMPLETELY COOLED, OTHERWISE, YOU MAY BURN YOURSELF AND/OR A FIRE MAY BREAK OUT IN FUEL LINE.
- BEFORE DISCONNECTING FUEL HOSE, RELEASE FUEL PRESSURE.
- BE SURE TO HOIST ENGINE AND TRANSAXLE IN A SAFE MANNER.

CAUTION:
- Position vehicle on a flat and solid surface.
- Place chocks at front and back of rear wheels.

1. Remove engine undercover and hood.
2. Drain coolant from both cylinder block and radiator.
3. Remove vacuum hoses, fuel hoses, wires, harnesses and connectors.
4. Remove front exhaust tubes, ball joints and drive shafts.
5. Remove radiator and fans.
6. Remove drive belts.
7. Remove alternator, compressor and power steering oil pump from engine.
8. Set a suitable transmission jack under transaxle. Hoist engine with engine slinger.





9. Remove rear engine mounting.





10. Disconnect control rod and support rod from transaxle.





12. Remove front engine mounting.





13. Remove center member and then slowly lower transmission jack.





14. Remove engine with transaxle as shown.
15. Reverse procedure to install, noting the following.
- When installing bearings, pistons, or other sliding parts lubricate contacting surfaces with new engine oil.
- Place removed parts such as bearings and bearing caps in their proper order and direction.
- When installing connecting rod nuts, and main bearing cap bolts, apply new engine oil to threads and seating surfaces.
- Do not allow any magnetic materials to contact the signal plate teeth of flywheel or drive plate.