Code 0407

Crankshaft Position Sensor (CKPS) (REF)

COMPONENT DESCRIPTION
The crankshaft position sensor (REF) is located on the oil pan (upper) facing the crankshaft pulley. It detects the TDC (Top Dead Center) signal (120° signal).
The sensor consists of a permanent magnet, core and coil.
When engine is running, the gap between the sensor and the crankshaft pulley will periodically change. Permeability near the sensor also changes.
Due to the permeability change, the magnetic flux near the core is changed. Therefore, the voltage signal generated in the coil is changed. The ECM receives the voltage signal and detects the TDC signal (120° signal).





CONSULT REFERENCE VALUE IN DATA MONITOR MODE
- Specification data are reference values.





ECM TERMINALS AND REFERENCE VALUE

Remarks: Specification data are reference values, and are measured between each terminal and (25) (ECCS ground) with a voltmeter.





ON BOARD DIAGNOSIS LOGIC

DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE

With Consult
(1) Turn ignition switch "ON" and select "DATA MONITOR" mode with CONSULT.
(2) Start engine and run it at least 2 seconds at idle speed.

OR

With Generic Scan Tool
(1) Start engine and run it at least 2 seconds at idle speed.
(2) Select "MODE 7" with GST.

OR

Without Scan Tool
(1) Start engine and it at least 2 seconds at idle speed.
(2) Turn ignition switch "OFF", wait at least 5 seconds and then turn "ON".
(3) Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECM.

EC-REF-01 Crankshaft Position Sensor (CKPS) (REF) (DTC: P1335):

Crankshaft Position Sensor (CKPS) (REF) (DTC: P1335):

DIAGNOSTIC PROCEDURE








COMPONENT INSPECTION

Crankshaft position sensor (REF)
1. Disconnect crankshaft position sensor (REF) harness connector.
2. Loosen the fixing bolt of the sensor.
3. Remove the sensor.
4. Visually check the sensor for chipping.
5. Check resistance as shown in the figure.

Resistance: Approximately 470 - 570 Ohms [At 20°C (68°F)]