CONSULT Inspection Procedure
SELF-DIAGNOSTIC PROCEDURE WITH CONSULT1. Turn on CONSULT.
2. Touch "A/T".
3. Touch "SELF-DIAG RESULTS".
Display shows malfunction experienced since the last erasing operation.
NOTE: CONSULT also performs REAL-TIME SELF-DIAGNOSIS; any malfunction detected while in this mode will be displayed at real time.
Diagnostic Display Tables
Malfunction Indicator Display Table (Part 1 Of 2):
Malfunction Indicator Display Table (Part 2 Of 2):
OBD-II "A/T INITIAL START" TROUBLE CODE
"A/T INITIAL START" may appear when you access the self-diagnostic results in the A/T system using CONSULT (see Figure 1).
This message indicates that the self-diagnosis results of self-learning have not been memorized in the A/T control unit. This message is stored in the self-diagnosis memory of the A/T control unit whenever the following systems are disrupted:
- The battery cable is disconnected
- The power supply line is short circuited
- The connector at the A/T control unit has poor contact
- The fuse in the power supply circuit burns out
- The connector from the A/T control unit is disconnected
- The A/T control unit is replaced
- The battery runs down or the battery is replaced.
Service Procedure
Figure 2.:
Erase "A/T INITIAL START" from the self-diagnostic results using CONSULT (see Figure 2). An actual DTC would have replaced "A/T INITIAL START" if there had been an incident with the transmission after the power to the A/T control unit was interrupted. Therefore, it is not necessary to drive the vehicle after erasing the DTC.