Diagnosis Mode

Inspecting SRS malfunctioning parts by using "AIR BAG" warning lamp - Diagnosis mode





1. Open driver's door.
2. Turn ignition switch from "OFF" to "ON".
3. Press driver's door switch at least 5 times within 7 seconds after turning ignition switch "ON". SRS is now in Diagnosis mode.
4. "AIR BAG" warning lamp operates in Diagnosis mode as follows:

NOTE:
If SRS does not enter diagnostic mode, go to DIAGNOSTIC PROCEDURE 10.
Procedure 10 SRS Does Not Enter Diagnostic Mode

5. Malfunctioning part is indicated by the number of flashes. Compare the number of flashes to WARNING LAMP FLASH CODE CHART, and locate malfunctioning part.
Warning Lamp Flash Code Chart

6. Turn ignition switch "OFF", and disconnect both battery cables.





7. Repair the system as outlined by the "Repair order" in WARNING LAMP FLASH CODE CHART that corresponds to the flash code. For replacement procedure of component parts.
Warning Lamp Flash Code Chart

8. After repairing the system, go to DIAGNOSTIC PROCEDURE 5.
Final Check After Repairs Diagnosis/User Mode