System Inspection of Maintenance Items

1. Check "AIR BAG" warning lamp:
^ After turning ignition key to "ON" or "START" position, "AIR BAG" warning lamp illuminates. The "AIR BAG" warning lamp will go out after about 7 seconds, if no malfunction is detected. When a warning lamp flashes, check and correct cause of the problem.

2. Visually check SRS components:
(a) Sensors
^ Check sensors to ensure the arrow marks face the front of the vehicle.
^ Check body and sensor brackets for deformities or rust.
^ Check sensor case for dents, cracks, deformities or rust.
^ Check sensor harness for binds, connector for damage, and terminals for deformities.

(b) Diagnosis unit - Airbag:
^ Check case and bracket for dents, cracks or deformities.
^ Check connectors for damage, and terminals for deformities.

(c) Air bag module and steering wheel:
^ Remove air bag module from steering wheel or instrument panel. Check harness cover and connectors for damage, terminals for deformities, and harness for binding.
^ Install driver side air bag module to steering wheel to check fit or alignment with the wheel.
^ Check steering wheel for excessive free play.
^ Install passenger side air bag module to instrument panel to check fit or alignment with the instrument panel.

(d) Spiral cable:
^ Check spiral cable for dents, cracks, or deformities.
^ Check connectors and protective tape for damage.
^ Check steering wheel for noise, binding or heavy operation.

(e) Main harness and air bag harness:
^ Check connectors for poor connections, damage, and terminals for deformities.
^ Check harnesses for binding, chafing or cut.

CAUTION: Replace previously used screws with new ones.

(f) Seat belt pre-tensioner:
^ Check harness cover and connectors for damage, terminals for deformities, and harness for binding.
^ Check belts for damage and anchors for loose mounting.
^ Check retractor for smooth operation.
^ Perform self-diagnosis for seat belt pre-tensioner using seat belt warning lamp or CONSULT.