Collision Diagnosis

Collision Diagnosis

To repair the SRS "AIR BAG", perform the following steps.

When air bag deploys in a collision:

1. Replace the diagnosis unit.

2. Remove the air bag module.

3. Check the SRS components using the table shown below:
^ If any damage is visible (such as dents, cracks or deformation), replace the damaged component.

4. Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp. Ensure the entire SRS operates properly except open circuits of air bag module and seat belt pre-tensioners.

5. Install new air bag module and seat belt pre-tensioners.

6. Conduct self-diagnosis again.

When air bag does not deploy in a collision:

1. Check the SRS components using the table shown below:
^ If any damage is visible (such as dents, cracks or deformation), replace the damaged component.

2. Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly.