Buffing

Buffing is done with a 8" buffer at 1500-1750 RPM to remove sanding scratches.

1. Clean the surface of all residue before buffing.

2. Apply a buffing liquid and spread it over the work area (2' x 2' or less) with the buffing pad before turning the buffer "ON". Keep the pad nearly flat and move it slowly but continuously over the area. Use an overlapping pattern to assure even buffing effort on all areas. Do not buff dry. Wipe off excess material with a clean terry cloth towel.

INSPECTION

Inspect the surface for sanding marks under full sunlight or with a 500 watt halogen work lamp held at an angle about an arms length away. If necessary, gently clean a small section of the surface with PPG DX330 Wax and Grease remover or similar wax remover, using a clean towel to remove any polish filler. Wipe in one direction to aid in distinguishing between buffing scratches and towel scratches.