With Manufacturer's Scan Tool

Self-diagnosis

Using Consult

The self-diagnosis results can be read by CONSULT, as follows:






1 Connect "CONSULT" to data link connector for CONSULT. (Data link connector for CONSULT is located in the fuse box.)
2. Turn ignition switch to "ON". (When CONSULT is connected, the "AIR BAG" warning lamp will be turned to present diagnosis mode.)
3. Touch "START" to operate "CONSULT".





4. Touch "AIR BAG" to choose air bag system.
5. Touch "SELF DIAG RESULTS" to read self-diagnosis results.









6. Problem codes are displayed on "SELF-DIAG RESULTS".
7. When "PRINT" is pressed, information displayed on "SELF-DIAG RESULTS" is printed out.
8. After repairing malfunctioning parts, press "ERASE" to clear self-diagnosis results.
- If malfunctioning parts are not completely repaired, "AIR BAG" warning lamp will blink every 0.5 seconds.
9. Push Back Key of CONSULT until SELECT SYSTEM mode appears to make "SELF-DIAGNOSIS" user mode.
10. Push the power off switch.
11. Turn off ignition switch, disconnect CONSULT.
12. Turn ignition switch to "ON".
- "AIR BAG" warning lamp should come on for about 7 seconds and then go off.