Collision Diagnosis

Collision Diagnosis





To repair the SRS "AIR BAG", perform the following steps:

When air bag deploys in a collision:

1 ) Replace the diagnosis (control) unit.
2 ) Remove the air bag module.
3 ) Check the SRS components using the table.
- If any damage is visible (such as dents, cracks or deformation), replace the damaged component.
4 ) Conduct self-diagnosis using CONSULT or"AIR BAG" warning lamp. Ensure the entire SRS operates properly except open circuits of air bag module and seat belt pre-tensioners.
5 ) Install new air bag module and seat belt pre-tensioners.
6 ) Conduct self-diagnosis again.

When air bag does not deploy in a collision:

1 ) Check the SRS components using the table.
- If any damage is visible (such as dents, cracks or deformation), replace the damaged component.
2 ) Conduct self-diagnosis using CONSULT or "AIR BAG" warning lamp to ensure entire SRS operates properly.