Code 35

EGR Temperature Sensor Test:

EGR Temp. Sensor Test:

EGR TEMPERATURE SENSOR (DTC: P1401)
For malfunction (a)
1) Turn ignition switch "ON" and confirm that voltage between ECM terminal (51) and ground more than 2.35V. (If necessary, wait until the engine coolant temperature is the same as atmosphere temperature.)
2) Start engine and run it for at least 8 seconds at idle speed. (Under the voltage between ECM terminal (51) and ground more than 2.35V)
3) Turn ignition switch "OFF", wait for at least 3 seconds and then "ON".

Switching Test Modes:

4) Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECCS Control Module.

For malfunction (b)
1) Start engine and warm it up sufficiently.
2 Turn ignition switch "OFF", wait for at least 3 seconds and then start engine again.
3) Run the engine for at least 5 seconds at idle speed.
4) Turn ignition switch "OFF", wait for at least 3 seconds and then "ON".

Switching Test Modes:

5) Perform "Diagnostic Test Mode 11 (Self-diagnostic results)" with ECCS Control Module.