Collision Diagnosis

Collision Diagnosis

To repair the SRS system, perform the following steps.
1. Check the control unit (diagnostic unit).

- Connect CONSULT and then erase the memory. (However, the
memory may not be cleared.)


OR



- Check "Air Bag" warning lamp and perform the following twice:
turn driver's door switch ON and OFF 5 times
within 7 seconds after the ignition switch is turned ON.


- If "Air Bag" warning lamp comes on continuously, than
-Replace the control unit-


2. Remove the deployed air bag modules and seat belt pretensioners.

3. Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as
dents, cracks, or deformation, replace them with new ones.

4. Conduct self-diagnosis using CONSULT or warning lamp to ensure
entire SRS operates properly except open circuits of air bag
modules and seat belt pre-tensioners

5. Install new air bag modules and seat belt pre-tensioners.

Collision Diagnosis Chart:

.