Without Scan Tool

CLEARING SELF-DIAGNOSTIC MODE
Self-diagnostic modes can be cleared using one of the following methods:

a. Set height control switch from "N" (normal) to "H" (high) while a self-diagnosis is being conducted.
b. Wait approximately five minutes after setting in the self-diagnosis mode.
c. Turn ignition switch "OFF".

CLEARING SELF-DIAGNOSTIC RESULTS

A faulty system indication is not cleared even after the faulty system has been repaired. To clear the indication, use one of the following methods:
- Set the self-diagnostic mode.
- Repeatedly depress and release (ON-OFF operation) foot brake at least five times within ten seconds.
- Self-diagnostic results will then be cleared.

NOTE: In cases where more than two system lines are faulty, repaired system indications will be cleared. However, any other faulty system will be indicated when self-diagnosis is performed again.