Splash Guards Part Number Chart

1. Remove the finisher, as shown (4 screws), and the wheelhouse finisher screw (located in-board.)





2. Install the Splash Guard with the same screws and tighten all screws securely. Push the Splash Guard inboard to minimize the gap at the body, while tightening the screws.





1. Remove the two bumper finisher screws located at the rear half of the wheel lip.

2. Pull back the finisher and remove the clip nuts.





3. Place the bracket behind the wheel lip and secure the top of the bracket with a screw.





4. Position Splash Guard and secure to the bracket with the remaining new screws. Push the Splash Guard inboard to minimize the gap at the body, while tightening the screws.

Left side:

5. Secure the rear of the Splash Guard to the tab with the new clip nut and self-tapping screw.

Right side:

5. Secure the inboard bracket of the Splash Guard to the wheel house with the existing screw.