Input Shaft Seal Replacement

Input Shaft Seal Replacement

Tools Required
* J 42738 Seal Installer
* J 36825 Output Shaft Oil Seal Remover

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the transfer case from the adapter. Refer to Transfer Case Assembly Replacement (Transfer Case Assembly Replacement).




3. Using the J 36825 remove the input shaft seal from the transfer case by threading the self tapping screw (2) into the seal.

Installation Procedure





Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (toward the technician). The input shaft seal should be even with the surface of the transfer case after installation.


1. Position the seal on the input shaft.
2. Using the J 42738 , install the input shaft seal in the transfer case.
3. Install the transfer case to the adapter. Refer to Transfer Case Assembly Replacement (Transfer Case Assembly Replacement).
4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).