Rear Seat-Back Cover Replacement

Rear Seat-Back Cover Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear the seams or damage the seat covers.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the rear seat-back.

2. Remove the clips (A) and detach the clips (B), then remove the striker hole cover (C).






3. Release the hooks (A), then remove the tether anchor cover (B).






4. Pull up on the screw cover (A), then remove the screw.





5. Pull up the rear edge of the lock knob trim (B) to release it from the lock knob pivot (C), then pull up on the front edge of the trim to remove it from the hole in the seat-back.

6. From behind the seat-back, release the hook strip (A), and unzip the seat-back cover (B).

Left side





Right side





7. Right side rear seat-back: Remove the screws, and release the hook (A), then remove the seat belt hole cover (B). Slip the rear center seat belt out through the slit (C) in the seat belt hole cover.






8. Detach the hooks (A), then remove the headrest guide (B).

Left side





Right side





9. Right side rear seat-back: Pull up on the seat-back cover, then remove the guide trim (A).






10. Remove the seat-back pad (A) from the seat-back frame (B).

Left side





Right side





11. Pull back the edge of the seat-back cover all the way around, and release the clips (A), then remove the seat-back cover.

Left side





Right side





12. Install the cover in the reverse order of removal, and note these items:

- To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the clips, the hooks, and the hook strips.
- Replace any clips (A) you removed with new ones.