Center Console Armrest Replacement

Center Console Armrest Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

For some models

NOTE:

- Take care not to scratch the center console.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the center console Center Console Removal / Installation.

2. Gently pull out the center console rear trim (A) to detach the hooks (B) and the clip.






3. Remove the screws (A, B), then remove the center console armrest (C).






Console box replacement

4. If equipped, disconnect the USB unit connector (A), detach the harness clips (B), and remove the screws, then remove the console box (C).





5. Install the armrest in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the USB unit connector is plugged in properly.