Symptom Troubleshooting

Navigation System Symptom Troubleshooting - Voice control does not work/respond

Voice control does not work/respond

NOTE:

- Check the vehicle battery condition first 12 Volt Battery Test.
- Make sure that the latest navigation software is installed.
- Before assuming that a voice complaint is hardware related, ensure that the voice control system is being operated correctly.
- Make sure you are on the correct screen when trying to issue a voice command. For instance, the command "Find the nearest Italian Restaurant" only works on Map screen. (See the Navigation Manual for a complete list of allowed voice commands for the information being displayed)
- Close the windows and moonroof
- Set the fan speed to low (1 or 2)
- Adjust the air flow from the air conditioning vents so that they do not blow against the microphone on the ceiling
- Pause after pressing the TALK button then give a voice command clearly in a natural speaking voice. If the system cannot recognize your command, speak louder
- If you speak a command with something in your mouth, or your voice is too husky, or high pitched, the system may misunderstand your command

- Check the connectors for poor connections or loose terminals.
- Check for a loose roof console microphone; if it's loose, tighten it.
- Determine if the problem only happens to one person, or everyone who uses the system.
- If the system only has a problem with one person's voice, this should be considered a system limitation.
- Check any official Honda service website for more service information about the navigation system.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Check for the hard error code.

Is there a hard error code stored?

YES -

Refer to the hard error code troubleshooting.

NO -

Go to step 4.

4. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode.

5. Select the Mic in the System Links.

6. Check for HFL DTCs.

Is DTC B1775, B1776, B1779, or B1780 indicated?

YES -

Troubleshoot the indicated DTC(s).

NO -

Go to step 7.

7. Return to the System Diagnostic Mode, and select the Detail Information & Setting.

8. Select the Unit Check.

9. Use the Steering Key in the Hard Key to check the operation of the TALK and BACK buttons.

Are the TALK and BACK buttons operational?

YES -

Check the operation of the voice control system (see the Navigation Manual).

NO -

Go to step 10.

10. Turn the ignition switch to LOCK (0).

11. Do the Voice Control Switch Test Voice Control Switch Test.

Is the voice control switch OK?

YES -

Replace the audio-navigation unit Audio-Navigation Unit Removal/Installation.

NO -

Replace the HFL-navigation voice control switch Voice Control Switch Replacement.