Transfer Assembly Installation

Transfer Assembly Installation

1. Install the transfer breather hose bracket (A) on the transfer assembly.






2. Clean the areas where the transfer assembly contacts the transmission with solvent, and dry with compressed air. Then apply ATF to the contact area.

3. Install the 14 x 20 mm dowel pin (A) in the transmission, and install the transfer assembly (B) on the transmission.






4. Install the No. 1 propeller shaft (A) to the transfer companion flange (B) by aligning the reference mark (C).






5. Connect the transfer breather hose (A) over the breather pipe (B) with the dot mark (C) facing the rear of the vehicle, then install the hose on the clamp (D) at the dot mark (E).






6. Install exhaust pipe A with the new self-locking nuts and new gaskets (B) (C) Service and Repair.






7. Refill the transfer assembly with transfer fluid (hypoid gear oil), if necessary.

8. Move the shift lever to P.

9. Refill the transmission with ATF.