Transmission Mount Replacement
Transmission Mount Replacement
1. Do the 12 volt battery removal procedure.
2. Remove the air cleaner Service and Repair.
3. Disconnect the ECM/PCM connectors (B).
4. Remove the harness clamps (C), auxiliary under-hood relay box A, and the ECM/PCM (D).
5. CVT model: Remove the harness clamp (E).
6. Support the transmission with a jack and a wood block under the transmission.
7. Remove the ground cable (A) and the harness holder (B).
M/T model
CVT model
8. Remove the transmission mount bolts (C) and nuts (D), then remove the transmission mount bracket (E).
9. Remove the transmission mount (A).
M/T model
CVT model
10. Install the transmission mount, and loosely install new transmission mount mounting bolts, then tighten the transmission mount mounting bolts in the numbered sequence shown.
11. Install the transmission mount bracket (A), and loosely install new transmission mount bracket mounting bolts (B) and nuts (C).
M/T model
CVT model
12. Install the harness holder (D) and the ground cable (E).
13. Remove the jack and the wood block from under the transmission.
14. Raise the vehicle on the lift.
15. Loosen the torque rod mounting bolt (A) and nut (B).
M/T model
CVT model
16. Lower the vehicle on the lift.
17. Tighten the transmission mount mounting bolts and nuts in the numbered sequence shown.
M/T model
CVT model
18. Raise the vehicle on the lift.
19. Tighten the torque rod mounting bolt and nut in the numbered sequence shown.
M/T model
CVT model
20. Install the ECM/PCM with the ECM/PCM bracket. Then connect ECM/PCM connectors A, B, and C.
NOTE: ECM/PCM connectors A, B, and C have symbols (A=(square), B=(triangle), C=(circle)) embossed on them for identification.
21. Install the harness clamps (D) and auxiliary under-hood relay box A (E).
22. CVT model: Install the harness clamp (F).
23. Do the 12 volt battery installation procedure.
24. Install the air cleaner Service and Repair.
25. Do the ECM/PCM reset procedure.