M/T Main Shaft Disassembly

M/T Mainshaft Disassembly

Special Tools Required

- Bearing Separator 07KAF-PS30200

NOTE: Refer to the Exploded View in the Mainshaft Reassembly, as needed, when removing components pressed onto the mainshaft M/T Main Shaft Reassembly.

1. Support 6th gear (A) on bearing separator (B), and press the mainshaft out of the angular ball bearing (C) and 6th gear.






2. Remove the needle bearing (A), the 6th gear distance collar (B), the synchro ring (C), the synchro spring (D), and the 5th/6th synchro sleeve (E).






3. Support 5th gear (A) on bearing separator (B), and press the mainshaft out of the 5th/6th synchro hub, synchro spring, the synchro ring, and 5th gear.






4. Remove the needle bearings (A), the 4th/5th gear distance collar (B), the 4th gear (C), the synchro ring (D), the synchro spring (E), and the 3rd/4th synchro sleeve (F).






5. Support 3rd gear (A) on bearing separator (B), and press the mainshaft out of the 3rd/4th synchro hub, the synchro spring, the synchro ring, 3rd gear, and the needle bearing.