Flywheel Housing CVTF Feed Pipe/Feed Pipe Guide Replacement (CVT)

Flywheel Housing CVTF Feed Pipe/Feed Pipe Guide Replacement

1. Remove the snap ring (A) from the flywheel housing on the CVTF feed pipe/feed pipe guide (B), then remove the CVTF feed pipe/feed pipe guide.






2. Remove the feed pipe guide (A) from the CVTF feed pipe (B), and remove the O-rings (C) from the feed pipe guide.





3. Replace the CVTF feed pipe or the feed pipe guide, then install new O-rings to the feed pipe guide.

4. Install the CVTF feed pipe through the feed pipe guide.

5. Install the CVTF feed pipe/feed pipe guide (A) to the flywheel housing by aligning the CVTF feed pipe tabs (B) with the guides (C) on the flywheel housing.






6. After installing the CVTF feed pipe/feed pipe guide, install and check that the snap ring is seated in the feed pipe guide and the housing groove, and that the ring end gap (A) is 5.4 mm (0.213 in) or more.