Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the 12 volt battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front inner fender Front Inner Fender Replacement.

3. Disconnect the left or right front impact sensor 2P connector (A) on the left or right engine compartment wire harness.





4. Remove the TORX bolt (B) using a TORX T30 bit, then remove the front impact sensor (C).

Installation

1. Install the front impact sensor (A) with a new TORX bolt (B), using a TORX T30 bit.





2. Connect the left or right front impact sensor 2P connector (C) on the left or right engine compartment wire harness.

3. Reinstall the front inner fender Front Inner Fender Replacement.

4. Do the 12 volt battery terminal reconnection procedure.

5. Clear any DTCs with the HDS.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.