Radiator And A/C Condenser Fan, Motor, And Shroud Removal And Installation

Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation

Removal

1. Raise the vehicle on the lift.

2. Remove the splash shield Splash Shield Replacement.

3. Remove the A/C compressor clutch connector (A) from the clamp, then remove the harness clamps (B).





4. Lower the vehicle on the lift.

5. Remove the intake air tube (A) and the resonator chamber joint (B).






6. Disconnect the fan motor connectors (A), and remove the harness clamps (B).






7. Remove the coolant reservoir (A).





8. Remove the A/C condenser fan shroud assembly (B), then remove the radiator fan shroud assembly (C) from the A/C condenser fan shroud side.

9. Disassemble the fan shrouds.






Installation

1. Assemble the fan shrouds.






2. Install the radiator fan shroud assembly (A) onto the A/C condenser fan shroud side, then install the A/C condenser fan shroud assembly (B).





3. Install the coolant reservoir (C).

4. Connect the fan motor connectors (A), and install the harness clamps (B).






5. Install the resonator chamber joint (A) and the intake air tube (B).

NOTE: When tightening the screw (C) of the hose band, align the edge of the hose band (D) with the mark (E) painted on the hose band. If you tighten the screw over the mark, replace the hose band.





6. Raise the vehicle on the lift.

7. Install the A/C compressor clutch connector (A) to the clamp, then install the harness clamps (B).





8. Install the splash shield Splash Shield Replacement.

9. Lower the vehicle on the lift.