Power Door Lock Actuator: Testing and Inspection

Door Lock Actuator Test

Driver's Door

1. Remove the driver's door panel Door Panel Removal / Installation.

2. Disconnect the 10P connector (A) from the door latch (B).






3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





4. If the actuator does not operate as specified, the actuator is faulty; replace the driver's door latch Service and Repair.

Passenger's Door

1. Remove the passenger's door panel Door Panel Removal / Installation.

2. Disconnect the 10P connector (A) from the door latch (B).






3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





4. If the actuator does not operate as specified, the actuator is faulty; replace the passenger's door latch Service and Repair.