Fuel Door: Service and Repair

Fuel Fill Door/Adapter Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Take care not to scratch the body.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the fuel cap (A) by turning it counterclockwise, and remove the screw.






2. Remove the left rear wheel, remove the fuel fill pipe cover Fuel Fill Pipe Cover Replacement, then lower the fuel fill pipe as needed Service and Repair.

3. Carefully pull the fuel fill door/adapter lip (A) off of the fuel fill pipe (B).






4. Detach the hooks (C, D), then pull out the fuel fill door/adapter (E) toward you.

5. Remove the fuel fill door/adapter (A).

1. Pull out the portion (B) of the hinge from inside the body.

2. If necessary, release the hooks (C), then remove the fuel fill door push lifter (D) from the fuel fill door/adapter.

NOTE: If you are only removing the fuel fill door/adapter, go to step 7. If you are doing further disassembly, proceed to step 6.





Fuel fill adapter bracket replacement

6. If necessary, pull out the fuel fill adapter bracket (A) and the fuel fill adapter lock grommet (B).

NOTE: When reinstalling the packing, be sure the arrow mark (C) on the packing is the upper side of the packing.






7. Install the fuel fill door/adapter in the reverse order of removal, and note these items:

- Make sure the adapter lip (A) is fully seated on the fuel fill pipe (B).
- Push the hooks (C) into place securely.