Output Shaft (Countershaft) Speed Sensor Replacement (A/T)

Output Shaft (Countershaft) Speed Sensor Replacement

1. Do the battery removal procedure Removal and Replacement.

2. Remove the 6 x 1.0 mm bolt securing the resonator bracket under the battery base bracket, and remove the battery base and the battery base bracket in the engine compartment.

3. Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A) and the sensor washer (B).





4. Install a new O-ring (C) on a new output shaft (countershaft) speed sensor, then install the output shaft (countershaft) speed sensor with the sensor washer.

5. Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

6. Install the battery base bracket and the battery base, and secure the resonator bracket under the battery base bracket with the bolt.

7. Do the battery installation procedure Removal and Replacement.