Driver's Power Seat Motor Test

Driver's Power Seat Motor Test

Driver's Seat without DPMS

NOTE:

- SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service and Repair before doing repairs or servicing.
- For DPMS power seat motor test Drivers Power Seat Motor Test (With Driving Position Memory System (DPMS))

1. Remove the driver's seat.

2. Remove the power seat adjustment switch knobs and the recline cover from the seat Front Seat Cushion Cover Replacement.

3. Disconnect the 12P connector (A) from the power seat adjustment switch (B).






4. At the 12P connector of the driver's seat wire harness side, test the motor by applying battery power and ground to the terminals according to the table.

Slide motor





Recline motor





Front up-down motor





Rear up-down motor





5. If the motor does not run or fails to run smoothly, go to step 6.

6. Disconnect the 6P or 2P connector from each motor.

NOTE:

- For the recline motor, remove the seat-back cover Front Seat-Back Cover Replacement.
- All connector views are wire side of female terminals.









7. Check for continuity between each motor 6P or 2P connector and the driver's seat wire harness 12P connector. If there is continuity, replace the appropriate motor:

- Slide motor
- Front up-down motor/seat frame Front Seat Frame Replacement
- Rear up-down motor/seat frame Front Seat Frame Replacement
- Recline motor

NOTE: The front and rear up-down motors are part of the seat frame.