Excessive Shock Or Flares On 2-3 Upshift Or 3-2 Downshift

Excessive shock or flares on 2-3 upshift or 3-2 downshift

A/T clutch pressure control solenoid valve B defective

A/T clutch pressure control solenoid valve C defective

Transmission fluid pressure switch B (3rd clutch) defective

Foreign material in separator plate orifice

2nd accumulator defective

3rd accumulator defective

2nd check ball stuck

2nd clutch defective

3rd clutch defective

Notes

Test the solenoid valve function with the HDS.

Notes

Inspect the A/T clutch pressure control solenoid valve body gasket, the ATF feed pipes, and the O-rings for wear and damage.

Notes

Check for a clogged orifice in the transmission fluid pressure switch connector. If the orifice is clogged, remove it, and clean the connector.

Notes

Check for a clogged orifice in the separator plate. If the orifice is clogged, remove it, and clean the separator plate orifice.

Notes

Check the ATF strainer for debris. If the strainer is clogged with particles of steel or aluminum, inspect the ATF pump. If the ATF pump is OK, find the damaged components that caused the debris. If no cause for contamination is found, replace the torque converter.

Notes

Inspect the 2nd and 3rd accumulator pistons, the O-rings, and springs for wear and damage in the servo body.

Notes

Check that the 2nd check ball is not stuck in the main valve body.

Notes

Check the 2nd and 3rd clutch pressures A/T Pressure Test.

Notes

Inspect the secondary shaft, the mainshaft, the 2nd clutch, and the 3rd clutch for wear and damage.

Notes

Inspect the clutch piston, the clutch piston check valve, and the O-rings. Check the spring retainer for wear and damage. Inspect the clearance between the clutch end-plate and the top disc. If the clearance is out of tolerance, inspect the clutch discs and the plates for wear and damage, and inspect the clutch wave-plate height. If the discs and the plates are worn or damaged, replace them as a set. If the wave-plate height is out of tolerance, replace the wave-plate. If they are OK, adjust the clearance with the clutch end-plate.

Notes

Inspect the 2nd and 3rd clutch feed pipes.

Notes

If the 2nd clutch feed pipe is scored, replace the end cover.

Notes

If the 3rd clutch feed pipe is scored, replace it and the O-rings under the feed pipe flange.

Notes

Replace the secondary shaft if the bushing for the 2nd clutch feed pipe is loose or damaged.

Notes

Replace the mainshaft if the bushing for the 3rd clutch feed pipe is loose or damaged.