Oil Pressure Sender: Service and Repair

Engine Oil Pressure Switch Replacement

1. Remove the front undercover and the splash shield.

2. Remove the A/C condenser fan shroud assembly Service and Repair.

3. Remove the A/C compressor without disconnecting the A/C hoses.

NOTE: Hang the A/C compressor with a rope.

4. Disconnect the oil pressure switch 1P connector (A), then remove the oil pressure switch (B).





5. Remove all of the old liquid gasket from the switch mounting hole.

6. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the new oil pressure switch threads. Install the component within 5 minutes of applying the liquid gasket.

NOTE:

- Using too much liquid gasket may cause liquid gasket to enter the oil passage or the end of the oil pressure switch.
- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.

7. Install the oil pressure switch.

8. Connect the oil pressure switch connector.

9. Loosely install the A/C compressor mounting bolts and the A/C compressor through bolt in the numbered sequence shown. Failure to follow this sequence may reduce the life of the drive.

10. Install the A/C condenser fan shroud assembly Service and Repair.

11. Install the splash shield and the front undercover.