B1228

DTC Troubleshooting: B1228 (D)

DTC B1228 or DTC indicator D:

A Short in the Outside Air Temperature Sensor Circuit

1. Clear the DTC with the HDS.

2. Turn the ignition switch to LOCK (0), and then turn to ON (II).

3. Do the Self-Diagnostic Function with the HDS or the climate control unit.

4. Check for DTCs.

Is DTC B1228 or D indicated?

YES -

Go to step 5.

NO -

Intermittent failure. Check for loose wires or poor connections on the outside air temperature circuit.�

5. Turn the ignition switch to LOCK (0).

6. Remove the outside air temperature sensor Service and Repair, and test it Outside Air Temperature Sensor Test.

Is the outside air temperature sensor OK?

YES -

With the outside temperature sensor disconnected, go to step 7.

NO -

Replace the outside air temperature sensor.�

7. Disconnect climate control unit connector A (32P).

8. Check for continuity between climate control unit connector A (32P) terminal No. 25 and body ground.





Is there continuity?

YES -

Repair a short to body ground in the wire between the climate control unit and the outside air temperature sensor.�

NO -

Go to step 9.

9. Check for continuity between climate control unit connector A (32P) terminals No. 19 and No. 25.





Is there continuity?

YES -

Repair a short in the wires between the climate control unit and the outside air temperature sensor.�

NO -

Substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit Climate Control Unit Removal/Installation.�