Key Interlock Solenoid Test

Key Interlock Solenoid Test

NOTE: SRS components are located in this area. Review the SRS component locations 4-door,2-door, and precautions and procedures before doing repairs or service.

1. Remove the steering column cover.

2. Disconnect the steering lock 6P connector (A).






3. Insert the ignition key in the key cylinder, then turn the ignition key to ACCESSORY (I).

4. Connect power to steering lock 6P connector terminal No. 4, and ground 6P terminal No. 3. Check that the ignition key cannot be turned to LOCK (0). Disconnect power and check that the key can be turned to the LOCK (0) position and removed from the cylinder.

5. If the key interlock solenoid works improperly, replace the ignition key cylinder/steering lock Service and Repair.