Transmission Speed Sensor: Service and Repair

Input Shaft (Mainshaft) Speed Sensor Replacement

1. Do the battery removal procedure Removal and Replacement.

2. Remove the 6 x 1.0 mm bolt securing the resonator bracket under the battery base bracket, and remove the battery base and the battery base bracket in the engine compartment.

3. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).





4. Install a new O-ring (B) on a new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor.

5. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

6. Install the battery base bracket and the battery base, and secure the resonator bracket under the battery base bracket with the bolt.

7. Do the battery installation procedure Removal and Replacement.