Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal

NOTE: Do not turn the ignition switch to ON (II) while removing the driver's seat position sensor.

1. Raise the seat all the way up.

2. Remove the driver's seat Front Seat Removal/Installation.

3. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).





4. Remove the nut (C), then remove the driver's seat position sensor.

Installation

NOTE:

- Be sure to install the harness so it does not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II) while installing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the driver's seat position sensor (A) with a nut (B), then connect the driver's seat wire harness 2P connector (C) to the driver's seat position sensor.





2. Reinstall the driver's seat Front Seat Removal/Installation.

3. Clear any DTCs with the HDS.

4. Check the operation of the driver's seat position sensor with the HDS Driver's Seat Position Sensor Operation Check.

5. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.