J35Z3 Engine

Cylinder Head Cover Removal

Front

1. Remove the intake manifold Intake Manifold Removal/Installation.

2. Remove the three ignition coils from the front cylinder head Service and Repair.

3. Disconnect the EGR valve connector (A), the front secondary HO2S connector (B), the front A/F sensor connector (C), and the harness clamp (D) securing the harness holder, and remove the dipstick (E).





4. Remove the bolt (F) securing the harness holder.

5. Remove the front cylinder head cover.






Rear

1. Remove the intake manifold Intake Manifold Removal/Installation.

2. Remove the three ignition coils from the rear cylinder head Service and Repair.

3. Remove the drive belt Service and Repair.

4. Remove the power steering pump and the power steering hose bracket with its hoses connected.

5. Remove the harness holder mounting bolts (A) and the engine ground cable (B).





6. Disconnect the three injector connectors (C) and the two harness clamps (D).

7. Disconnect the breather hose (E).

8. Remove the harness (F) from the upper cover.

9. Remove the rear cylinder head cover.