DTC Troubleshooting

DTC Troubleshooting: P0BFD (30)

DTC P0BFD (30):

Motor Current Sensor Circuit Malfunction

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.
- If the DTC cannot be cleared, do the troubleshooting for DTC U1204 (55).

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Start the engine.

4. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0BFD (30) indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time.�

5. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0A5E (24), P0A5F (25), P0A61 (26), P0A62 (27), P0A64 (28), or P0A65 (29) indicated?

YES -

Go to the indicated DTC's troubleshooting.�

NO -

Replace the phase motor current sensor Service and Repair, then go to step 6.

6. Start the engine.

7. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P0BFD (30) indicated?

YES -

Go to step 1.

NO -

Go to step 8.

8. Monitor the OBD STATUS for DTC P0BFD (30) in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES -

Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 7, go to the indicated DTC's troubleshooting.�

NO -

If the screen indicates FAILED, go to step 1. If the screen indicates NOT COMPLETED, keep the ignition switch ON (II) until a result comes on.