Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley Removal and Installation

Special Tools Required

- Holder Handle 07JAB-001020B
- Holder Attachment, 50 mm, Offset 07MAB-PY3010A
- Socket, 19 mm 07JAA-001020A

Removal

1. Raise the vehicle on the lift.

2. Remove the right front wheel.

3. Remove the engine undercover.





4. Remove the drive belt:

- '10 model Service and Repair

5. Hold the pulley with the holder handle (A) and the holder attachment, 50 mm, offset (B).





6. Remove the bolt with a heavy duty socket, 19 mm (C) and a breaker bar, then remove the crankshaft pulley.

Installation

1. Remove any oil and clean the pulleys (A), the crankshaft (B), the bolt (C), and the washer (D). Lubricate with new engine oil as shown.






2. Install the crankshaft pulley, then tighten the bolt. Do not use an impact wrench.

1. Hold the pulley with the holder handle (A) and the holder attachment (B). Torque the bolt to 65 Nm (6.6 kg-m, 48 lb-ft) with a torque wrench and the heavy duty 19 mm socket (C).

2. Tighten the bolt an additional 60 °.









3. Install the drive belt:

- '10 model Service and Repair

4. Install the engine undercover.






5. Install the right front wheel.