Side Impact Sensor (Second) Replacement

Side Impact Sensor (Second) Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the rear seat-back Rear Seat Removal/Installation.

3. Disconnect the floor wire harness 2P connector (A) from the side impact sensor (second) (B).





4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the side impact sensor (second).

Installation

1. Install the side impact sensor (second) (A) with the new TORX bolt (B), using a TORX T30 bit.





2. Connect floor wire harness 2P connector (C) to the side impact sensor (second).

3. Install the rear seat-back Rear Seat Removal/Installation.

4. Do the battery terminal reconnection procedure Procedures.

5. Clear any DTCs Reading and Clearing Diagnostic Trouble Codes.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.